Journal Paper

1. "Optimal design of plate-fin heat exchangers by a bees algorithm"
   hoseyn zare : First author, Salem Mehrzad : second author, Afshin Ghanbarzadeh : Third author
   Modarres mechanical engineering journal, pp.22-29, 2012
2. "Power Augmentation of Gas Turbine by Inlet Air cooling and Study the Effect of Air Moisture on Cycle Elements"
   Salem Mehrzad : First author, mahmoud Chahartaghi : second author
   journal of Solids and Fluids, pp.91-99, 2011
3. "Modeling and Design of a Multistream Plate-Fin Heat Exchanger in the Air Separation Units by Pinch Technology"
   الیاسین نزار : First author, Salem Mehrzad : second author, Mohammad Reza Saffarian : Third author
   International Journal of Chemical Engineering, pp.1-16, 2023
4. "An investigation of multistream plate-fin heat exchanger modelling and design: a review"
   الیاسین نزار : First author, Salem Mehrzad : second author, Mohammad Reza Saffarian : Third author
   Kerntechnik, pp.1-18, 2023
5. "Design of the Multistream Plate-Fin Heat Exchanger in the Air Separation Units"
   الیاسین نزار : First author, Salem Mehrzad : second author, Mohammad Reza Saffarian : Third author
   International Journal of Heat and Technology, pp.187-196, 2023
6. "Three-Dimensional Simulation of Leakages in Rotary Air Preheater of Steam Power Plant"
   armin heidari : First author, Ebrahim Hajidavalloo : second author, Salem Mehrzad : Third author
   Heat Transfer Engineering, pp.1-18, 2021
7. "Experimental and numerical investigation of specific energy consumption of the two-stage pneumatic-fluidized bed drying of suspensiongrade polyvinyl chloride"
   مسعود درفشان : First author, Salem Mehrzad : second author, Ebrahim Hajidavalloo : Third author
   Drying Technology, 2020
8. "Experimental and numerical study of the effects of pre-drying of S-PVC using a pneumatic dryer"
   Salem Mehrzad : First author, Ebrahim Hajidavalloo : second author, مسعود درفشان : Third author
   powder technology, pp.220-232, 2018
9. "A comprehensive review on modeling of pneumatic and flash drying"
   Salem Mehrzad : First author, Ebrahim Hajidavalloo : second author, مسعود درفشان : Third author
   Drying Technology, pp.33-51, 2017
10. "Feasibility Study for Replacement of Renewable Sources of Energy in Selected Segments Fars Provice"
    Yaser Sahebi : First author, morteza almassi : second author, Mohammad Javad Sheikhdavoodi : Third author, Houshang Bahrami : Fourth author, ladan jokar : Author5, Salem Mehrzad : Author 6
    World Applied Sciences Journal, pp.232-239, 2014
11. "Economic and technical assessment of the desiccant wheel effect on the performance of cross flow cooling towers in variable wet bulb temperature"
    Salem Mehrzad : First author, ali chitsazan : second author
    Heat and Mass Transfer, pp.1587-1596, 2014
12. "INVESTIGATION OF HEAT TRANSFER PROCESSES INVOLVED LIQUID IMPINGEMENT JETS: A REVIEW"
    maysam molana : First author, Salem Mehrzad : second author
    brazilian journal of chemical engineering, pp.413-435, 2013
13. "Design and Validation of Perfusion Bioreactor with Low Shear Stress for Tissue Engineering"
    Anneh Mohammad Gharravi : First author, mahmoud Orazizadeh : second author, mahmood hashemi tabar : Third author, Karim Ansari-Asl : Fourth author, Salem Mehrzad : Author5, ali alifard : Author 6, sina izadi : Author 7
    Journal of Medical and Biological Engineering, pp.185-192, 2013
14. "Design and Fabrication of Anatomical Bioreactor Systems Containing Alginate Scaffolds for Cartilage Tissue Engineering"
    Anneh Mohammad Gharravi : First author, mahmoud Orazizadeh : second author, Karim Ansari-Asl : Third author, Salem Mehrzad : Fourth author, sina izadi : Author5, mahmoud hashemitabar : Author 6
    Avicenna Journal of Medical Biotechnology, pp.65-74, 2012
15. "Status of tissue engineering and regenerative medicine in Iran and related advanced tools: Bioreactors and scaffolds"
    Anneh Mohammad Gharravi : First author, mahmoud Orazizadeh : second author, mahmoud hashemitabar : Third author, Karim Ansari-Asl : Fourth author, Salem Mehrzad : Author5, ali alifard : Author 6, sina izadi : Author 7
    Journal of Biomedical Science and Engineering, pp.217-227, 2012
16. "Conference Report: First Middle East Drying Conference"
    Salem Mehrzad : First author
    Drying Technology, pp.898-899, 2011
17. "Impingement Heat Transfer Effects on Baking of Flat Bread"
    Salem Mehrzad : First author, seyed mostafa Hosseinalipour : second author, Arun Mujumdar : Third author, ehsan taheran : Fourth author, mohamad mashaiekhi : Author5
    Drying Technology, pp.910-919, 2009
18. "Baking of Flat Bread in an Impingement Oven: An Experimental Study of Heat Transfer and Quality Aspects"
    Salem Mehrzad : First author, seyed mostafa Hosseinalipour : second author, Arun Mujumdar : Third author, ehsan taheran : Fourth author, mehdi bahiraei : Author5, payman taherkhani : Author 6
    Drying Technology, pp.902-909, 2009
19. "Baking of Flat Bread in an Impingement Oven: Modeling and optimization"
    Salem Mehrzad : First author, seyed mostafa Hosseinalipour : second author, Arun Mujumdar : Third author, payman taherkhani : Fourth author, mehdi bahiraei : Author5
    Drying Technology, pp.103-112, 2009

Conference Paper

1. "Design of Refrigerant cooling for dehumidification of compreesed air system of drilling rig"
   فرشاد هاشمي نادر : First author, Ebrahim Hajidavalloo : second author, Salem Mehrzad : Third author, Keyvan Hasanzadeh : Fourth author
   30th International annual mechanical engineering conference, 2022
2. "prediction of temperature and water content of EPVC in pilot spray dryer"
   فرزاد جماعتي : First author, Salem Mehrzad : second author, مسعود درفشان : Third author
   The 16th Iranian National Congress of Chemical Engineering, 2019
3. "fissibility study and technical and economical investigation of gas heat pump application for summer peak load of ahvaz"
   Salem Mehrzad : First author
   4 th electrical energy consumption optimizing conference, 2018
4. "design of underground schools for energy saving in hot climate"
   sara chahartaghi : First author, Salem Mehrzad : second author, shaghayegh kazemi : Third author
   4th conference of energy trends in energy conservation, 2015
5. "Modeling and Experimental Investigation of a Two Stages Industrial Air Compression System"
   Salem Mehrzad : First author, Shahram Azizifar : second author
   The 22nd annual international conference on mechanical engineering, 2014
6. "Numerical Modeling of Two Dimensional Impingement Jet and Investigation of Heat Transfer and Stagnation Point Placement"
   Salem Mehrzad : First author, Aida Ehsani : second author, Shaghayegh Kazemi : Third author
   The 22nd annual international conference on mechanical engineering, 2014
7. "Designing and Investigation of Domestic Solar Water Heater with a Reservoir including Encapsulated Phase Change Materials"
   Mahsa Nazaripour : First author, Salem Mehrzad : second author
   21st International Conference on Mechanical Engineering, 2013
8. "thermodynamic modeling of two stage compressed air system"
   Salem Mehrzad : First author, shahram azizifar : second author, Mohammad Reza Saffarian : Third author
   International Conference on Mechanical Engineering and Advanced Technology, 2012
9. "Design of dessicant wheel for wet bult temperature control and improve cooling tower performance in ahvaz"
   ali chitsazan : First author, Salem Mehrzad : second author, Mohammad Reza Saffarian : Third author
   International Chiller and Cooling Tower Conference, 2012
10. "Simulation of transient behavior of oil coolingsystem of Abadan power plant"
    Ebrahim Hajidavalloo : First author, Salem Mehrzad : second author, alireza asgarpour : Third author
    20th annual International Iranian Mechanical Engineering Conference, 2012
11. "design and optimization of heat exchanger for indirect heat transfer in oven by beez algorithm"
    hossein zare : First author, Salem Mehrzad : second author
    Middle East Drying Conference, 2012
12. "find of optimum temperature in salt seperation from crude oil"
    neda neisi : First author, Salem Mehrzad : second author
    National Simposium on Novel Oil and Gas Technologies, 2011
13. "effect of increasing of mixing efficiency on crude oil desalting plant performance"
    neda neisi : First author, Salem Mehrzad : second author
    National Simposium on Novel Oil and Gas Technologies, 2011
14. "Efficiency reduction of power and steam production units due to operation in non-full loads"
    Salem Mehrzad : First author
    2nd Coference on Rotating Equipment (Iran Rotate 2010), 2010
15. "application if sun pipe in building illumination"
    Salem Mehrzad : First author, mohammad rezaie : second author
    The first national conference reform consumption pattern, 2010
16. "Nox reduction in gas turbine of mashhad power plant due to inlet air cooling of compressor"
    Salem Mehrzad : First author, seyed mostafa Hosseinalipour : second author
    Fuels and combustion of iran, 2010
17. "Analysis of specific energy consumption in S-PVC pneumatic drying"
    Salem Mehrzad : First author, Ebrahim Hajidavalloo : second author, مسعود درفشان : Third author
    International Conference on Mechanics of Advanced Materials and Equipment, 2018
18. "Prediction of heat transfer of a confined slot jet with the use of nanofluid: considering temperature dependent properties"
    Reza Bahoosh Kazerooni : First author, amir niroomandi : second author, Salem Mehrzad : Third author
    Seventh Student Conference on Iranian Mechanical Engineering, 2013
19. "Effect of dilution water salinity on required dilution water in a crude oil desalting plant"
    Nada Nessi : First author, Salem Mehrzad : second author
    Iranian chemical engineering congress, 2012
20. "Heat Transfer in Comercial Impingement Oven"
    Salem Mehrzad : First author, korosh goudarzi : second author, maysam molana : Third author
    Middle East Drying Conference, 2012
21. "INFRARED RADIATION EFFECT DURING BREAD BAKING IN COMBINED HEAT TRANSFER MEDIUM"
    Salem Mehrzad : First author, majid afaghi : second author, maysam molana : Third author
    Middle East Drying Conference, 2012
22. "EFFECT OF IMPINGEMENT OVEN FINGER DUCT SHAPE ON JETS VELOCITY"
    Salem Mehrzad : First author, maysam molana : second author
    Asia-pasific drying conference, 2011
23. "Effect of mixing efficiency in dilution water consumption in a crude oil desalting plant"
    Nada Nessi : First author, Salem Mehrzad : second author
    International Conference on Chemical, Biological and Environmental Engineering, 2011
24. "NUMERICAL INVESTIGATION OF AIR FLOW PATH FOR AN AIR IMPINGEMENT FINGER DUCT"
    Mohammed Daganiyan : First author, Salem Mehrzad : second author, Ebrahim Hajidavalloo : Third author
    The 13th annual and 2nd International Fluid Dynamics Conference , FD2010, 2010
25. "ELIMINATION OF BREAD VOLUME EXPANSION EFFECT WITH NEW IMPINGEMENT OVEN DESIGN"
    Salem Mehrzad : First author, Arun Mujumdar : second author
    17th International drying symposium, 2010
26. "NUMERICAL MODELING OF THE SIMULTANEOUS HEAT AND MASS TRANSFER INSIDE THE IRANIAN BREAD DURING BAKING IN AN IMPINGEMENT OVEN"
    payman taherkhani : First author, seyed mostafa Hosseinalipour : second author, Salem Mehrzad : Third author, ehsan taheran : Fourth author, mehdi bahiraei : Author 5, Arun Mujumdar : Author 6
    15th Regional Symposium on Chemical Engineering (RSCE), 2008
27. "emperical study of jet temperature and velocity effects on Iranian bread baking in an impingement oven"
    mehdi bahiraei : First author, seyed mostafa Hosseinalipour : second author, Salem Mehrzad : Third author, ehsan taheran : Fourth author, payman taherkhani : Author 5, Arun Mujumdar : Author 6
    15th Regional Symposium on Chemical Engineering (RSCE), 2008